so - I have a 960 that I purchased 2-3 years ago - I've gone thru a lot of it and have been using it to pick up slack when the other tractors are busy - I hooked it to the mower today - the mower has a hydraulic cylinder that is adjusted by the remote valve -
the valve has three detents/positions - it picks up the mower fine, but when the control is shifted to the middle position it releases the pressure and the cylinder drops - I need it to hold the cylinder where it's set -
This is a little different style valve than is on the other tractors - see picture -
I'm wondering if anyone here recognizes this valve and has any suggestions for what I might do to have it operate the way I need -
the valve has three detents/positions - it picks up the mower fine, but when the control is shifted to the middle position it releases the pressure and the cylinder drops - I need it to hold the cylinder where it's set -
This is a little different style valve than is on the other tractors - see picture -
I'm wondering if anyone here recognizes this valve and has any suggestions for what I might do to have it operate the way I need -