881 drawbar question

Lynn Patrick

Well-known Member
Working on my 881 this morning. It is set up w/the under-belly bracket for a drawbar, but has no drawbar. I have a complete set-up for an 8N w/a new drawbar & one on my 960. Both of these pin the drawbar differently, the 8N w/a lynch pin to hold the pin in, & the 960 has a spring-loaded pin that turns to lock in. The 881 has neither, so my question is, what holds the 881 pin in, & what does the pin look like. I have not yet found anything in my FO-20, Owner's Manual or Parts Book. Does anyone have a pic of theirs, a diagram, part #, etc.... I hope to use the 8N drawbar. Is it different from the right one for the 881?
Thanks for any help!
Lynn
 

311920 is the NH part number. It is item number 9 in the 881 parts diagram. You'll find that diagram under group 07 - Hydraulic Systems subsection Swinging Drawbar

It is somewhat of a uniquely shaped hairpin cotter. The pin itself is cylindrical with a tapered end and a groove for the hairpin cotter to fit in.

The 8N drawbar is not the same as the 881. I do not know if it'll even fit. Perhaps someone else can answer that question for sure,
 
Here's the one for your 881. I'm not sure which drawbar you have on your 8n so can't say weather it will fit.

Kirk
100_4205_zps7qrfo66p.jpg
 
Thanks for the replies! You guys always come through!!
The 8N drawbar fits, & I made a pin w/a 1/4" hole near the top end & stuck a long 1/4" bolt thru it. It'll hold until I can get a real one!
Thanks again!!
 

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top