Patrick Potter
Member
The 3 point still is not holding it
drifts down, I put in a new cylinder
seal kit and that did fix the leak at
the piston but it still goes down and
when I try using the auger it will not
pull it out of the hole only after
going a little over a foot into the
ground any suggestions, I'm leaning
towards rebuilding the pump
drifts down, I put in a new cylinder
seal kit and that did fix the leak at
the piston but it still goes down and
when I try using the auger it will not
pull it out of the hole only after
going a little over a foot into the
ground any suggestions, I'm leaning
towards rebuilding the pump