Cleaning out the top of the loft at work I found an old gardner denver pump, big flywheel pulley, 2 groove.
I spun her by hand, she sucks and blows, sounds good.
The data plate was gone, but this was stamped under the 4 rivits where the plate was
1-ACD-9
Any ideas on how many HP I need to drive this? As best I recall we used this at work on a horizontal tank back in about 87, then the motor was stolen and we took the pump off and stored it, and tank was old and scrapped.
i have a spare upright 80g tank now.. just wondering what motor to power with?
we have single phase 220 service at the shop.
will 5hp pull this?
thanks
I spun her by hand, she sucks and blows, sounds good.
The data plate was gone, but this was stamped under the 4 rivits where the plate was
1-ACD-9
Any ideas on how many HP I need to drive this? As best I recall we used this at work on a horizontal tank back in about 87, then the motor was stolen and we took the pump off and stored it, and tank was old and scrapped.
i have a spare upright 80g tank now.. just wondering what motor to power with?
we have single phase 220 service at the shop.
will 5hp pull this?
thanks