(800) 853-2651
SHOP NOW

2000/300/4000 hydraulic adjustment

A

Alan8n

Member
I have an 58 861 and been having trouble with my lift. Found that I have a "BLUE" code cylinder and some parts for it are NLA. Ford NH lists a C5NN477B as a replacement and I think I am going to bite the bullet and try one.
Thought about used and I can get one with a 90 day warranty. That's OK but man, put it on to find I have a worse problem then when I started ???
I think I will need to figure out my draft/position adjustments and thinking a manual for a 2000/3000/4000 would be what I should follow ??
Can someone confirm what Manual for those tractors may have the setup info I am looking for ??
Don't want to spend big bucks on a service manual just to see what the hydraulic setup is, especially if I find out that they are not applicable to what I am trying to do.
Thanks...
Alan
 
The cylinder they show as a replacement looks very different from my original and I dont know what the draft/positon numbers are. I know how to set up what I have , .390 and .448 I think if memory serves me correct, but no one can tell me what the setup is for the cylinder I am getting.
So I am guessing that it would be for the later models and figured I would check those manuals out to see if they look like what I am getting. I don't want to spend the $$$ for a manual I may not need.
Making the adjustments for the older models have been discussed many times on the forum and have successfully done it on my tractors several times, I never see any discussions about the newer models, so I don't know if the setup is the same or not.
Do you suspect that I should just set it up like the original ?
I would like to try and get right the first time rather than trial and error. They get heavier each time you pull them off
Thanks
 
You must log in or register to reply here.

Similar threads

B
Ford 2000 PTO shaft seal leaking
Replies
2
Views
91
Bennett French
B
D
1963 Ford 2000 Hydraulic Filter
Replies
9
Views
277
showcrop
showcrop
G
Ford 4000 Jerky Hydraulics
Replies
2
Views
191
Ggray
G
F
Ford 4000 selectOspeed adjustment
Replies
4
Views
554
shaun wallace
S
D
Need help finding drag links
Replies
16
Views
463
Duner Wi
D
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top