(800) 853-2651
SHOP NOW

NAA Instrument Cluster

F

FarmerHR

Member
I recently bought a Ford NAA to turn into a work tractor.
There is a about a one inch hole in the sheet metal between the three gages (Temp, Oil Pressure, Amp Meter) with nothing in it. Looking through my manuals, I have not been able to determine what goes in the hole.
Can someone tell me what goes in the hole ?
Many Thanks for your fine help.
 
Thank you for the replies. Your answer makes perfect sense. Next job is to locate a light assembly.
Thank again
 
You must log in or register to reply here.

Similar threads

R
641 Sheetmetal on NAA/Jubilee
Replies
4
Views
311
Kirk-NJ
K
gears
Ohms for 3000 sending units?
Replies
6
Views
364
Hobo,NC
Hobo,NC
sixbales
Sockets for Instrument Cluster Lights Ford 3930
Replies
6
Views
646
sixbales
sixbales
T
Tale of two,Positive Grnd
Replies
6
Views
471
JMOR
J
T
Converting a Ford instrument panel to fit a CaseIH
Replies
4
Views
378
Texasmark
T
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top