(800) 853-2651
SHOP NOW

Ford 8670 PTO clutch... trying to rip it apart...

K

kuleckjared

New User
This message is a reply to an archived post by John_PA on June 10, 2012 at 02:15:26.
The original subject was "Ford 8670 PTO clutch... trying to rip it apart...".

I am going through all this right now....Yes, you have got to take the bottom pan cover off, and yes you have got to pull the output shaft...This is prob a 2 person process.....How can I help you? 8145943178....Thanks, Jared
 
Wow!

You dug up an old post! Yeah, I got that done back then, and everything has been holding up well. I did it by myself, unfortunately, as I don't have any helpers for mechanical stuff. I'm glad I had some nice alignment bars to help guide that cover back on. Definitely a heavy one!
 
You must log in or register to reply here.

Similar threads

H
Ford 4400 timing
Replies
2
Views
274
Heet0006
H
M
Ford 860, PTO Disengages under heavier load?
Replies
0
Views
246
Mreestwould
M
F
92 Ford 4630 8x8 to 8x2 Transmission Swap?
Replies
2
Views
270
Ford62b
F
F
Case powershift valve removal??????
Replies
2
Views
366
used red MN
U
N
Ford 5000 clutch and PTO input shaft
Replies
1
Views
383
Bern
B
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top