A follow up on a question I posted recently about installing electronic ignition on my ford 3000 3 cyl. My thanks to you who replied with some good info.
I ordered the kit from this site and yesterday I tackled what I knew would be a challenge for an old fella with a bad case of the tremors.
As I mentioned before I thought the instructions were pretty broad but found a switched wire and proceeded to remove the points etc.
To make a long story short I reached the point where on completing the installation of kit I found the dust cover would not fit over the magnet'
I figured I must have the wrong kit so I proceeded to remove it and reinstall the points.
Feeling mighty perturbed I quit and called yt to complain, At customer service at YT the gentleman who took my call researched my problem and said that the dust cover is not used in this application'
It sure would have nice if that one sentence had been included in the instructions
I ordered the kit from this site and yesterday I tackled what I knew would be a challenge for an old fella with a bad case of the tremors.
As I mentioned before I thought the instructions were pretty broad but found a switched wire and proceeded to remove the points etc.
To make a long story short I reached the point where on completing the installation of kit I found the dust cover would not fit over the magnet'
I figured I must have the wrong kit so I proceeded to remove it and reinstall the points.
Feeling mighty perturbed I quit and called yt to complain, At customer service at YT the gentleman who took my call researched my problem and said that the dust cover is not used in this application'
It sure would have nice if that one sentence had been included in the instructions