(800) 853-2651
SHOP NOW

860 lift cover

F

flory

New User
I have gone through some other posts to rebuild the
lift cover on my 860 and they were very helpful.
The problem I am having is I have very little
movement of the position control handle. The
hydraulic lift control lever moves freely on the
shaft, but the drawbar control arm is moving with
the shaft. Is that normal or should they both move
freely?
 
(quoted from post at 08:16:09 05/24/14) I have gone through some other posts to rebuild the
lift cover on my 860 and they were very helpful.
The problem I am having is I have very little
movement of the position control handle. The
hydraulic lift control lever moves freely on the
shaft, but the drawbar control arm is moving with
the shaft. Is that normal or should they both move
freely?
Click to expand...
our terminology/names of items leaves much to be desired. Difficult to answer when can't determine the question. Lift arms are keyed to shaft, so move together. Touch control lever is also keyed to its shaft & as such should not "move on the shaft". I'll assume "position control handle" is the DRAFT/POSITION mode selector, about 3 inches long at top right of lift cover. It has a horiz & vertical positions & only moves 90 degrees.
 
I am using names from the parts manual. The parts
are the ones that attach to the lift control shaft
inside the cover and control the linkage. I took
them off again and re-cleaned them. Now the lever
moves like it should. I guess I missed something
before.
 
I'm looking at the FO-20 & still don't know parts you are referencing........but that's OK, I don't need to, since you seem to have cleared the problem.
 
You must log in or register to reply here.

Similar threads

B
Unloader Valve or Control Valve?
Replies
2
Views
156
Bob in Tennessee
B
K
Ford 600 hydraulics control lever will only move an inch, will not raise implement
Replies
1
Views
140
Sean in PA
S
J
Lift issues....
Replies
11
Views
579
joshbruce128
J
L
4000 4 cyl hydraulic question?
Replies
7
Views
339
showcrop
showcrop
Josh M.
Ford 3000 draft control
Replies
9
Views
707
wp6529
W
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top