(800) 853-2651
SHOP NOW

ford 2600 Lift arms

L

Larry Peterson

New User
Hi My lift arms work fine except they wont raise very high. I have a loader on that works fine so I don't think the problem is in the pump. Wher should I start?
 
for kicks.. manipulate the draft control and see if there is any change int he position control height.

in any case.. I think you will find her ready for a new cam follower pin, perhaps some building up ont he cam.. and then a linkage adjustment using the shop manual. if it refers to using a nuday tool, look for the alternate instructions . all the nuday tool is is , esentially, a measuring device/ etc.
 
Many Thanks,
I'll try the draft control, but it's actually the orchard variety and has only one lever. The draft control is a small lever on the right side below the seat. I'll let you know what results I get.
 
no change to the directions. manipulate the draft control to see what it does to the position control.
 
Hi,
No lift at all in draft mode. And When checking the oil level the FO-41 manual says arms up and all cylinders extended, but the owners manual says arms up and all cylinders retracted. Do you know which is correct?
Again Thanks
 
If your loader has double acting cylinders for the lift arms and the bucket, then the small difference between fully extended and fully retracted shouldn't make much of a difference, but I believe that the proper procedure is with the arms up and all cylinders extended, that way you're checking the fluid level in the reservoir when it will be at its lowest, and you want enough in there to keep the differential and rear axle bearings lubricated when the fluid is at its lowest possible level.
 
it won't make a difference that you could see on the stick. the lift cyl volume is minutia compaired to sump volume...

if you have some large external hyds using SA cyls.. then it would make a difference..
 
You must log in or register to reply here.

Similar threads

J
6610 lift arms
Replies
2
Views
196
jledlow
J
D
Ford 4000 Hydraulics
Replies
9
Views
546
David Adams
D
R
Lift arms stuck up
Replies
7
Views
465
Red Rex
R
J
Lift issues....
Replies
11
Views
510
joshbruce128
J
K
Hydraulic will not work at all
Replies
12
Views
973
kcurry681
K
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top