Yesterday's Tractor Co. Shop Now
   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
Classified Ads
Photo Ads
Tractor Parts

Discussion Forums
Project Journals
Tractor Town
Your Stories
Show & Pull Guide
Events Calendar
Hauling Schedule

Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs

Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

Related Sites
Tractor Shed
Ford 8N/9N Club
Today's Tractors
Garden Tractors
Classic Trucks
Kountry Life
Ford Tractors Discussion Forum
Order Ford 5000 Parts Online

Re: Ford 5000 electricalgenerator

[Show Entire Topic]  

Welcome Guest, Log in or Register
Author  [Modern View]

05-01-2013 06:17:34

Report to Moderator

If the proof meter is working and the tach is not working then the cable and drive system is fine.... the proof is working. The problem is internal to the tach workings... so basically you have a junk tach.
As far as the charging problems go.... that's pretty much normal for those systems. You gravitate between bad regulators and bad generators and back again until you have enough and install a Delco 10si alt.
In your situation.... if you have an engine that was built after 1972 and it has the welch plug above the oil pump drive (just below the oil filter) and also has a factory spin on filter.... I'd just install the tach drive in that welch plug hole. You will need a new oil pump drive shaft/gear with the square drive hole, the angle drive, a new cable for a 5600 and an instrument cluster for a 5600. I'd probably go with a Tisco unit myself...
Then install a Delco 10si alt from NAPA with a lifetime warranty. You need to modify the lower bracket and extend the length and carve the upper one. Wiring needs to be updated a bit but that is simple. Once done... it's DONE, and it charges.
If you have an older block and require the tach drive to remain on the alt/gen... you can buy a modified Delco 10si for this specific purpose, from Tisco. This site retails Tisco stuff....


[Log in to Reply]   [No Email]
[Show Entire Topic]     [Options]  [Printer Friendly]  [Posting Help]  [Return to Forum]   [Log in to Reply]

Hop to:

Fast Shipping!  Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]

Home  |  Forums

Copyright © 1997-2018 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters