660 lift controls.

Robert NC · Feb 22, 2013

Bit the bullet and pulled the lift top to replace the seals on the lift cylider. The lift lift control shaft coming through the lift cover has slop between the shaft and the lever that fits on it inside the cover. I have another shaft and lever from a 660. Can I change shaft and levers and not have to worry about resetting all the clearance. Hope I am making sense.

Thanks in advance

Dean · Feb 22, 2013

You need to replace the cam follower pin and readjust the draft and position control adjustments while the lift cover is off in any event.

Dean

souNdguy · Feb 22, 2013

ditto what dean said.

lift cover kit is 15 $.. don't half arse the job.. do the cam pin and cam if needed ( braze / weld / grind ).. then repalce all orings and piston seal/washer.. readjust using alt method without nuday tools.. etc. be good another 50 ys after that.

Robert NC · Feb 23, 2013

Is the pin available or should I just braze it and the file/grind it round and smooth?

660 lift controls.

Robert NC

Member

Dean

Well-known Member

souNdguy

Well-known Member

Robert NC

Member

Similar threads