Re: Hydraulic Flow Rates in reply to soundguy, 01-24-2013 08:19:29
I agree, if this was a business or even if I had a lot to split I would use the gas engine. But, I'm married, so "investment capital" is much harder to get then "operational cost." That means I can't buy either the PTO or gas engine pump, but spending $20 at a time on fuel several times is an easier expense to get approved.
Re: Hydraulic Flow Rates in reply to Brian in MA, 01-24-2013 09:32:21
Only a woman could rationalize that line of thinking... but I hear your problem. The 5600 will make about 12 at 2100 rpm. It'll mabey make 7-8 at a brisk idle. I'd try to get a big Prince pump as quick as I could. Not the little one, the big, 22 gpm one.
Just leave the Briggs engine to rot somewhere else.
Re: Hydraulic Flow Rates in reply to RodInNS, 01-24-2013 11:47:00
It's not necessarily about rationalizing, more about not wanting to go to the well again at this point. Once I have a usable tool it's easier to get upgrades. Now I just have a pile of parts. And I ordered the splitting wedge this morning and once she sees the credit card charge I'll have to explain that one too. I just remembered I have an old Howard Power Arm backhoe with a PTO pump, I'll have to dig that out of the snow to see what flow that pump is, maybe I already own the solution. Thanks for the info.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.