Author	[Modern View]
AKSport 09-19-2012 21:47:22 216.137.195.193 Report to Moderator	This message is a reply to an archived post by Corey148 on March 09, 2012 at 12:06:31. The original subject was "Ford NAA vs. Ford 600 or 601 series". Hi, New here and a little off topic. I need fender and hood parts for a 600 and I need to know if NAA parts are the same. Any info is appreciated. [Reply]   [No Email]
soundguy 09-20-2012 08:46:04 173.104.45.108 Report to Moderator	Re: Ford NAA vs. Ford 600 or 601 series in reply to AKSport, 09-19-2012 21:47:22   UD covered it pretty good. even if not completely correct.. it should bolt up. ditto on dash differences and dash cowling from lateer 01 tin to the naa.. etc. [Reply]  [No Email]
Ultradog MN 09-20-2012 03:40:46 174.20.247.199 Report to Moderator	Re: Ford NAA vs. Ford 600 or 601 series in reply to AKSport, 09-19-2012 21:47:22   I'm more of a 3 cyl man but will give it a try. NAA 600 tin should be just about identical. There might be some differences like a gas gauge or hole for a light in the dash. The 601 side hoods will not have the Ford script on the side and again the dash and under dash tin may have an extra hole - like for the SOS PTO cable or an extra light. All of the tin from a NAA, 600 and 601 will be a direct swap from one to another. Fenders for an NAA are the same as for an 8N. Fenders for a 600 are somewhat unique and harder to find as they only used them for a couple of years. The 601 used a fender with Ford script that was the same from about 1957 through the 2000 tractor in early 1965. After that the fender is the same shape and size through 1975 but without the Ford script. Fenders from a 1939 ford will physically fit a ford through 1982 or so. I may be off on some of the fine points here but this will get you started. Other guys can give you more info. [Reply]  [No Email]