(800) 853-2651
SHOP NOW

Ford 3000 Valve Adjustment Questions

2

200cs

Member
I am wanting to adjust the valves in my tractor the next time I have it down for maintenance. However, I am a bit confused on the timing marks. It is a Ford 3000 Diesel and my IT Manual is not very specific regarding the marks and I want to be absolutely certain I am at TDC before any adjustments are made. I do not see any marks on the crankshaft pulley - should there be? I have read about the 19 degree BTDC mark on the right lower side of the engine back by the transmission. Is this the mark to use? I wish the IT manual was much more specific but it is not.

Thanks in advance for the help.
 
All that you have to do is remove valve cover and bump the engine over with the starter untill one valve is up all the way(closed) and the valve next to it is down all the way(open). Do this for each cyl. and mark each one that you do with a paint pen so you know which ones you have done. Good Luck.
 
Bill"s way is zacly like I do it on any engine ,,, takes the guess work out of it,,, yes takes a little longer but it will B rite
 
You must log in or register to reply here.

Similar threads

pcdreams2
ford 3000 timing
Replies
17
Views
465
560Dennis
560Dennis
D
help with Ford 3000 ID
Replies
2
Views
122
Andy Wickiser
A
G
Ford 3000 purchase (possibly)
2 3
Replies
40
Views
1K
Ultradog MN
Ultradog MN
G
Help Ford 3000 sos
Replies
14
Views
573
shaun wallace
S
M
Bush Hog Freeman loader 3000 fit Ford 3600
Replies
3
Views
397
Eman85
E
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top