This message is a reply to an archived post by Bill Brox on March 01, 2012 at 13:30:58.
The original subject was "Re: Cracked 80 mm Standard block.".
I have a TE20 wit h Standard engine and block is cracked at the bottom (near bottom of liners) between #3 and #4 cylinders. I"m worried about welding because of the liner sealing/gaskets near the bottom.
Any suggestions?????
The original subject was "Re: Cracked 80 mm Standard block.".
I have a TE20 wit h Standard engine and block is cracked at the bottom (near bottom of liners) between #3 and #4 cylinders. I"m worried about welding because of the liner sealing/gaskets near the bottom.
Any suggestions?????