(800) 853-2651
SHOP NOW

13.6 tires on to30?

The wheel center and rim are set up for a 28" tire. Are you replacing it down to the hub?

If just the tire it would not fit inside diameter is too small.
 
(quoted from post at 15:32:43 08/20/12) The wheel center and rim are set up for a 28" tire. Are you replacing it down to the hub?

If just the tire it would not fit inside diameter is too small.
Click to expand...

So these would not work? I did not plan on replacing the hub. From what i can tell the Ford 801 had 28" rims from the factory but seller had these on the tractor for a while.

http://buffalo.craigslist.org/grd/3214597860.html
 
Can't the rim be revirsed, install the tire also
reverse. Not sure but If I remembered correctly
it can be done, but measure before you buy the tires. ggp
 
What are they from? An AC I'll bet. Well, no wheel centers that fit a fergie are going to match up with 26" rim loopholes. If you had the wheel centers with the tires and rims, I doubt that will bolt up to the fergie hub and lug studs. You can measure everything on you tractor and compare to the stuff for sale... but a fit up is unlikely...
 
(quoted from post at 22:20:27 08/20/12) What are they from? An AC I'll bet. Well, no wheel centers that fit a fergie are going to match up with 26" rim loopholes. If you had the wheel centers with the tires and rims, I doubt that will bolt up to the fergie hub and lug studs. You can measure everything on you tractor and compare to the stuff for sale... but a fit up is unlikely...
Click to expand...

The rims are not loopholes, the craigslist link shows pictures of the rims/tires. All the measurements are the same regarding the studs and center cutout.
 
You must log in or register to reply here.

Similar threads

J
Cylinder Head studs, nuts and washers for a TO30 (Z129 block).
Replies
1
Views
63
pomester
P
J
Tire recommendations
Replies
15
Views
968
caterpillar guy
C
M
TO30 tachometer
Replies
4
Views
264
Bruce(OR)
B
4
Cockshutt 540? rear rims
Replies
12
Views
558
scootergmc
S
EX Deere Farmer
TO30 rear wheel bolt pattern????
Replies
1
Views
119
Moonlite37
M
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top