(800) 853-2651
SHOP NOW

To30 live pto/hydraulics

A

Arprod

New User
I have a to30 and want to have live pto and live hydraulics. I have read some forum post on this page, wanting to find parts needed. Thank you
 
I have a TO35, 1957 model, it has power spread wheels, and live clutch,
Works fine, but if you can afford it, as was said by others, get a later model as they improved the clutch pak as years when by,
 
A Z130 engine 'will' poorly fit a TO35 bellhousing, but non of the assemblies you want will fit in a 30's arsend. You need to shop for a TO35 or other model made with the machinery you want.
 
I have a TO30 with live power. It's rare. Has Sherman live PTO. They were available in the 50's. It will be hard to find but not a big job to install. I'll sell my 30 - has been restored-4 new tires and nice.
 
A Z129 plus one! That's watcha get after a really cool hot rod rebuild Richard!!

To tell the truth, its been so long since I got into one, I forgot the sizes. 120's are in TO20? 129 in TO30's only? 134 and then 145 and 175 or is it 176? in later bigger MF's right?

The numbers are too far apart on the board to pretend my finger hit the wrong keys... so I am stuck telling the truth again.....
 
Ok I only get involved with the Z 120 Z 129 and Z 134. Any bigger it is to much power for me to handle. I wanted to check & be sure my mind hasn't left me altogether YET. If they are not Fergie numbers I don't get involved. HA HA Well I do like the 327 with a 4 speed and a 5th under the seat in a 1965 Chevelle SS. OOPS sorry family forum.
 
Hey Miner! I'll swap ya a rust free Massey Harris 50 from New Mexico? I'll pour in a quart of gas. Good deal huh?
Been so long since I saw that 30- does that have the extra section of transmission? or it is all in side the bellhousing? I can't seem to post pictures on here lately, so when you can, take us some pics and see if you can post em up...
 
Tony Tony Tony you know the live hydraulic part doesn't go into the bell housing. If miner09 has an Everett I only wish I had some money to buy his tractor. Missed out again.
 
Iriv Slaughter from Oskaloosa, Iowa did have a TO 30 with a sherman OD and the Live PTO and spin out tires, and a tach. Not sure what he wanted for it.
 
You must log in or register to reply here.

Similar threads

T
TO30 Block shot. Can TO20 engine be used instead?
Replies
7
Views
649
William Fissell
W
Y
TO30 hydraulics raise but won’t lower
Replies
4
Views
242
Jerry/MT
J
C
TO30 Hydraulic issue
Replies
2
Views
480
cgejimmy
C
T
TO30 Block shot. Can TO20 engine be used instead?
Replies
0
Views
320
TO 30 Steve
T
A
TO30 Gears do not move when shifting
Replies
9
Views
297
AllanK
A
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top