hi guys.
I have replaced one liner ( yes i know its not the best ,but thats the way it is)
Anyway with the new liner installed it is sitting proud of the other 3 liners which are approx 0.07mm proud of the bore.
The new liner is aprox 0 .10mm proud of bore. ( i think) .
I see the specs say liner standout 0.076 to 0.14 mm.
Wondering how much the copper gasket can accommodate for differences in liner standout and can i use gasket maker, holymer etc to provide an extra gasket on the 3 original liners to provide a seal.
I am not a metal person so not sure how much i can fudge this.
Its not practical at present to remove the other 3 liners, I need to get it re assembled and going.
I need to re measure these clearances for better accuracy, but advice from people with experience would be good.
Again thanks for your help.
Pete
I have replaced one liner ( yes i know its not the best ,but thats the way it is)
Anyway with the new liner installed it is sitting proud of the other 3 liners which are approx 0.07mm proud of the bore.
The new liner is aprox 0 .10mm proud of bore. ( i think) .
I see the specs say liner standout 0.076 to 0.14 mm.
Wondering how much the copper gasket can accommodate for differences in liner standout and can i use gasket maker, holymer etc to provide an extra gasket on the 3 original liners to provide a seal.
I am not a metal person so not sure how much i can fudge this.
Its not practical at present to remove the other 3 liners, I need to get it re assembled and going.
I need to re measure these clearances for better accuracy, but advice from people with experience would be good.
Again thanks for your help.
Pete