maxazillion
Member
Hello All,
I am in the process of rebuilding my TO 20 engine and have run into a snag with the thrust washer pins. The machine shop removed the old pins. I replaced with hardened steel pins because that was all I could find. Not knowing any better from lack of experience I drove the pins in to far. Now I cannot remove them or drill them out. Is it possible to reassemble the engine without the pins or do I have to get a new block. Thanks for any replies.
I am in the process of rebuilding my TO 20 engine and have run into a snag with the thrust washer pins. The machine shop removed the old pins. I replaced with hardened steel pins because that was all I could find. Not knowing any better from lack of experience I drove the pins in to far. Now I cannot remove them or drill them out. Is it possible to reassemble the engine without the pins or do I have to get a new block. Thanks for any replies.