(800) 853-2651
SHOP NOW

Governor and timing cover

V

Volksman79

Member
So I am about to take what is left of the old governor out and replace it with a new kit. I was reading the shop manual and it says to replace the gasket and seal when replacing the governor. The problem I have is what seal are they talking about? I can find a timing cover gasket but I can not seem to find a governor seal. Has anybody done this repair know what I need to get before I take it apart? Thanks
 
That is what I thought. When I search for parts a governor shaft seal comes up but I can not find it in the parts book. Only here on the yesterday tractors parts. 1750108M1. In the shop manual is says to remove the seal and replace it when when installing the new governor assembly. I guess I should replace the crank shaft seal as well. I am going to take it apart and see what is in there.
 
The governor bearing and seal is inside the timing cover where the governor arm comes out the side to connect to all the linkages. You have to drill the rivets out and then you can remove the governor arm. If there is no play in it then I wouldn't worry with it.
 
It is blown up. I found most of the pieces in the oil pan. Thanks for the heads up. I am going to take it apart tomorrow. Let you know what I find.
 
You must log in or register to reply here.

Similar threads

D
1947 Ford 2N governor upgrade.
Replies
4
Views
575
Tim PloughNman Daley RIP
T
D
ca front timing cover oil seal
Replies
3
Views
1K
thdrduck
T
Crazy Horse
Governor spring specification question .....
Replies
2
Views
222
Dieseltech
D
T
Ford 3000 governor linkage issues
Replies
0
Views
193
Travis152
T
M
TO 30 governors shim
Replies
6
Views
774
Duner Wi
D
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top