Hi
Bought an ORC for the tea20, only to discover that the male spline was 1 3/8. so back to farm supplies. to get adaptor to reduce it back to 1 1/8 to fit slasher yoke. ( the bloke at the shop was a tad slow. I had to explain it 6 times, and he still didnt understand and told me there was no such thing. ) Doh. so went and found it myself on the shelf....
So today went to fit it and i recon the shaft ( after cutting)is going to be to short to lift the slasher all the way up with ORC and the reducer on.
Also i recon there has to be a better setup. maybe replace the old yoke with1 3/8 yoke on slasher to fit onto the orc.
Also the ORC is not quick release, so want to return this one and get a quick release. which is best.
See photos and let me know your thoughts.
Bought an ORC for the tea20, only to discover that the male spline was 1 3/8. so back to farm supplies. to get adaptor to reduce it back to 1 1/8 to fit slasher yoke. ( the bloke at the shop was a tad slow. I had to explain it 6 times, and he still didnt understand and told me there was no such thing. ) Doh. so went and found it myself on the shelf....
So today went to fit it and i recon the shaft ( after cutting)is going to be to short to lift the slasher all the way up with ORC and the reducer on.
Also i recon there has to be a better setup. maybe replace the old yoke with1 3/8 yoke on slasher to fit onto the orc.
Also the ORC is not quick release, so want to return this one and get a quick release. which is best.
See photos and let me know your thoughts.
