(800) 853-2651
SHOP NOW

TO-30 Guages

M

magfarm

New User
Hello, I tried searching with no luck. What were the 3 original gauges on a TO-30 and their locations? Thank you.

Allan
 
Magfarm, the TO 30 came with an oil pressure gauge and a ammeter gauge. If you want to be a little safer many others and I have installed a water temp gauge also. Oil gauge on the right side of dash, water temp gauge on extreme left side of dash and the ammeter to left of the steering column.
 
Richard, thank you.
Is there a specific plug everyone uses on the block for the temp gauge probe? Any idea what size of fitting is needed?
 
Yes a plug is available but I do not have the size in order to tell you what to get. The way I understand you can get them at a hardware store. I hope someone will be nice enough to post a pic and the size. If I am able to get a picture of mine I will send it to you. It will be later today.
 
On the TO-30 I had the sending unit installed in the neck just below the top radiator hose.
a152088.jpg

a152089.jpg
 
Allan, the temperature gauge I picked up at the auto parts store had the correct adapter fitting for the plug in the neck on my TO-20. (There were several different adapters included.)

(EDIT) Allan, the Parts Book says that plug is a "Plug, 5/8", NF, Special".
 
To Del Huebner
What is that bracket behind the throttle lever? I have not seen that before. Does it limit the throttle levers upwards movement? I know sometimes when I open my hood and the throttle is up to high it hits the edge of the hood.
 
Ron, I think that is called the throttle control quadrant. There is no stops on it but it does help firm up the throttle rod and I think it is mainly used for selecting engine speed. It is standard equipment on the Fergusons.
 
Ron, I believe if you look around you will see those items mainly on Ford tractors. Some are plain and some have notches or grooves in them to help hold the throttle lever at same position. They use the same steering column bolts to hook it to the dash.
 
You must log in or register to reply here.

Similar threads

J
Kewanee 500 Elevator manual
Replies
6
Views
434
Still trying
S
A
135 rims on TO30?
Replies
2
Views
278
acaswell
A
D
Dash gauges...china stuff autozone
Replies
17
Views
533
DoubleO7
DoubleO7
C
Ford 6600 Gauges
Replies
8
Views
403
crankit
C
kcm.MN
Member Search
Replies
14
Views
231
cpratt
cpratt
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top