Fergy to-35
New User
is it possible to straighten radius rods?
- Thread starter Fergy to-35
- Start date
Yes..... A good block of wood and my friend the persuader and with a bit of care on the well placed blows......!
Never hit the radius bar direct, only hit the soft timber as the bar is just a shell of mild steel and will dent real easy. Set your foot on the timber to stop it bouncing as you hit it.
Sam
Never hit the radius bar direct, only hit the soft timber as the bar is just a shell of mild steel and will dent real easy. Set your foot on the timber to stop it bouncing as you hit it.
Sam
Bob (Aust)
Well-known Member
No point in straightening them if you don't first change the font axle center pivot pin.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy