Topic: Re: Connecting Rod Orientation
|Harry Ferguson Tractors Discussion Forum|
[Show Entire Topic] [Return to Forum]
[Show Entire Topic]
[Return to Forum]
[Add a Reply]
Probably just leave it as-is.
A number of possibilites:
1. Look for the correct position of the oil hole in the rod. (caps and rod may have been mismarked at factory)
2. If rod cap is simply just removed and piston/rod assembly rotated for correct orientation then piston will be backwards IF psiton has a front and back to it. OR maybe not. POssible that rod was put on piston wrong and therefore rod is backewards because piston/rod assembly was installed using front of piston as reference.
3.HAve to first determine if there is a "front" position for piston.
4.determine if rod in fact has an oil hole and it's correct position.
5. Determine that rod is not placed on piston backwards.
ALL of the above points have to be considered. Simply changing position of just one part might very well throw the other parts out of correct position. There is always (tho slim) possibility of incorrect marking of parts and or improper manufacture.
Note that rods assembled to pistons BACKWARDS is very common mistake made in engine building. Quite possible the rod is on the piston backwards.
This post was edited by PackardV8 at 20:03:04 01/22/13 2 times.
[Reply] [No Email]|
|Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]|
| Copyright © 1997-2013 Yesterday's Tractor Co.|
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
|About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.|