Just had our motor rebuilt and going to install it .
The locator pins were very hard to get out when
taking the motor out. . I checked the fitting on them
today into the housing and they are very snug to try
in go in . Is there any tricks to get them in and if
there is anything else to make the motor install
much easier .
Thanks Dan
The locator pins were very hard to get out when
taking the motor out. . I checked the fitting on them
today into the housing and they are very snug to try
in go in . Is there any tricks to get them in and if
there is anything else to make the motor install
much easier .
Thanks Dan