(800) 853-2651
SHOP NOW

IH 1066 Suitcase Weight Lock bar

T

tractorman9000

New User
Hello,
Have not used the forum in some time but recently purchased a 1973 IH 1066 and do not have the suitcase weight lock bar or angle iron. I have a 12 hole extended bracket that does not require the spacers and 12 big handle 100lb weights. What size is the factory size angle iron that I need for the lock bar? width and thickness? I already have the lock cams.
Thanks in advance!!!
 
I am really tempted to mess with you and say it's metric, but really, all you need to do is measure the slot hole in the weights and get a piece of angle that fits. On length make it the same as the width of the weight bracket.
 
Thanks for the reply . I know it's not rocket science and I will probably never fly this thing to the moon even though it runs pretty good at least without some serious help.
I can make any size angle work from 1 1/2" to 2 1/4" and any thickness up to 3/8" but since I am going to make one myself I would like to make it as close to the factory one as possible. Therefore I was trying to find out the actual measurement on the correct factory size of the angle iron and the thickness. already have the measurements for the length and where to drill the holes from the weight bracket.
 
You must log in or register to reply here.

Similar threads

L
Suitcase weight bracket bolt torque
Replies
1
Views
266
Fixingfarmer
Fixingfarmer
M
IH 350U cam shaft gear keyway
Replies
5
Views
277
Bob M
Bob M
F
IH 484 Loader Tractor
2 3
Replies
47
Views
2K
MARK ROBKE
M
D
Template for grinding lift cover opening for new cylinde
Replies
3
Views
660
Ultradog MN
Ultradog MN
T
Force and leverage?
Replies
7
Views
1K
Tractorcedric
T
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top