Super A Plow Mount

pacebm

New User
Hello all, this forum has been a great source of knowledge to me for the past few years. I can normally answer my questions without bothering anyone but I am stumped on this plow setup. I have searched the internet (forums, YouTube, Google) but I cannot figure out how to mount this plow. I know it was mounted to the tractor 30 years ago but I was 12 and I can't remember how to do it. Any advice would be helpful. I have attached pictures of what I have (maybe something is missing?).


A little introduction, this tractor was bought new in 1951 in North Alabama by my great grandfather and has been in the family ever since. He used it for everything until his death. Bigger and better tractors replaced it but I always like it so I kept it running. I don't use it much but decided to a plant garden this year. It runs well but has some leaks in the hydraulics and steering which I will be addressing soon.
mvphoto18776.jpg


mvphoto18777.jpg


mvphoto18778.jpg
 
Your plow is a A91 (for Farmall A) adapted for use with Super A. That is probably why you could not find it, if you were only looking for Super A plows.
Look for A91 manuals etc. and you'll find good help.
In any event, The v-shaped piece with the spring attaches to the back of the steering housing with two pins. The other end attaches to the front end of the plow beam.
The sector attaches to the right side of the clutch housing and the curved rod (curve up) goes between it and the plow beam.
The rear rockshaft goes where the regular rockshaft goes between the fenders and the rear support attaches to it.
The Super A hydraulics will control your depth and the hand lever will control the pitch of the plow.
 
The same plough and lifting arrangements for the Farmall Super A were used on the Geelong (IH Australia) GL-195 Two Furrow mouldboard plough (for use with Farmall Super A tractor). The Case and Vintage Farm Machinery Club of NZ (Inc), (Vintagemachinery.com) does have a copy of the owners manual and parts manual in their library
 
(quoted from post at 03:23:00 04/06/15) Thank you!! I knew y'all would point me in the right direction!!!

Hey....it is good to see another Alabamian. Welcome to the forum and that is some nice IH equiment you've got there! Let me know if I can help in any way. We have several of those old tractors and we are located just outside of Birmingham. I should have about any kind of part for the tractor or implements should you need anything ([email protected]).

Again...welcome!
 
(quoted from post at 03:23:00 04/06/15) Thank you!! I knew y'all would point me in the right direction!!!

Hey....it is good to see another Alabamian. Welcome to the forum and that is some nice IH equiment you've got there! Let me know if I can help in any way. We have several of those old tractors and we are located just outside of Birmingham. I should have about any kind of part for the tractor or implements should you need anything ([email protected]).

Again...welcome!
 

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top