farmall H bull pinion bearing cage o-ring

transtar61 · Dec 18, 2014

Looking for farmall H bull pinion bearing cage o-
rings dealer number is 422D . would like to find
after market o-rings. Thanks Scott

sflem849 · Dec 18, 2014

IIRC it was a quad ring. I think you will have to suck it up and buy the CNH one if you want it.

Nebraska Kirk · Dec 18, 2014

Correction on the part number, it should be 4222D.

I think that O-ring is a dealer only part. I don't know how expensive it is, but if you are looking for a cheaper alternative, determine the size of the O-ring and then go here:
www.theoringstore.com If they don't have the correct size, you can always make one out of cord stock.

gab · Dec 18, 2014

I wouldn't be too scared of the dealer, I needed the input shaft pilot brg. in the trans. of my Super M. Most of the stuff I read on here had me scared to get anything from IH. Tried all the local brg. places, called Motion Industries = $99. and 9 months to get. Some internet places showed it but when called nobody had it or knew for sure if and when they could get it. Finally called the IH dealer fifteen miles up the road with the pt number, he had 4 or 5 for about 54 bucks per.

NRG · Dec 18, 2014

I use part # 568-357 at my local hydraulic shop. Usually cost me about $5 pair. They are O-rings and not the square ones but I have good luck with them.

dej(Jed) · Dec 19, 2014

(quoted from post at 14:48:37 12/18/14) Looking for farmall H bull pinion bearing cage o-
rings dealer number is 422D . would like to find
after market o-rings. Thanks Scott

Measure it and go McMaster Carr's site they have a ton of them.

farmall H bull pinion bearing cage o-ring

transtar61

Member

sflem849

Well-known Member

Nebraska Kirk

Well-known Member

gab

Well-known Member

NRG

New User

dej(Jed)

Well-known Member

Similar threads