(800) 853-2651
SHOP NOW

Super A moldboard plow

T

TimnSEVA

Member
Picked up a Super A last fall that came with a single and a left &
right hand plow but I don't have the draft control bar for it and have
had no luck locating one. I need to plow about 1 acre, can i plow
without it and achieve good results or am i wasting my time?
Anyone have one for sale or measurement to fabricate my own?
Thanks
 
Make one and make it longer than you think so you will end up with one that works best because it does control your depth
 
Assuming you have the plows that bolt to the reversed U drawbar. If one point fast hitch, the draft control bar is essential. I used the drawbar plow for years without the draft control bar. Set the drawbar at it's lowest setting using the bolts that are there for adjusting the drawbar height. There is an eccentric bolt in the plow hitch that allows the plow side to side tilt to be adjusted. Tilt should be set so the plow bottom runs level at the depth you want when the tractor wheel is in the furrow. With drawbar at lowest setting and the tilt set correctly, you can plow without the draft control bar. It will take two or three passes to get the plow to go to depth because when you first start there is no furrow for the wheel to run in. If plow runs too deep, adjust with the rear rock shaft and the rear lift chains.
 
You must log in or register to reply here.

Similar threads

C
Adjusting an A193 plow
Replies
12
Views
468
BarnyardEngineering
BarnyardEngineering
M
Farmall C/Super C Liftall Differences?
Replies
2
Views
241
Harold Hubbard
H
B
Farmall Fast Hitch Plowing
Replies
10
Views
863
Absent Minded Farmer
Absent Minded Farmer
J
Looking for a shank for moldboard plow
Replies
3
Views
226
jpi72
J
B
IH Fast Hitch Plow and Disc ID
Replies
7
Views
781
Kevin Happke
K
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top