Final potos and info for C-153 in Super C

Here are the last photos of it almost complete.
Used the following parts for archives

Rear Fuel Tank support from Famall "A"---49601D

140 Radiator---369400R94

140 Radiator brace--369513R1

140 Lower Radiator Elbow 369396R1

140 Upper radiator outlet--367679R1

140 Upper Radiator Hose 369397R1

140 Lower Water Pump Hose 387721R1

140 Lower Radiator Hose-20075DB

Had to use original fan off of power unit but had to remove 1 1/4" off the ends of each blade
a165254.jpg

a165255.jpg

a165256.jpg

a165257.jpg

a165258.jpg
 
I am maybe going to put a shroud on it, I will use a 140 shroud and cut the top and bottom out and just use the side bolted to the rad.
 
Looks good, Rex. Just a couple questions.

Is the SC sheetmetal going to fit, or will you need to use 'hundred series' metal to fit the radiator? Is the 153 block longer than the 113/123, i.e.: is the hood going to fit?

What about hydraulics? It's essentially what put the Super in SC.
 
If you use the parts I listed the Super C sheet
metal fits perfect. I removed the touch control from
mine but the C153 has the hole for the hydraulic
pump so it should be the same hook up a Super C. It
was an easy project just a pain tracking down what
parts would work--thats why I included parts and
part numbers for the next person that comes along
 

I'd sure use a shroud if you can find or make one... we found it made a world of difference on a race car. There is almost no "suction" through the radiator without one.
 

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top