Had a little fun a few days back pre-heating, then welding the front bolster from my 424.
I used an industrial-strength Lincoln 3-phase motor-generator DC welder and nickle rod.
It seeming to weld pretty good after LOTS of pre-heating of both broken areas.
Darned camera battery went dead after this photo, so no pictures of the finished job!
<img src = "http://i167.photobucket.com/albums/u125/27Grainfield/424IH/FunWithFire_zps646c9f9e.jpg">
I used an industrial-strength Lincoln 3-phase motor-generator DC welder and nickle rod.
It seeming to weld pretty good after LOTS of pre-heating of both broken areas.
Darned camera battery went dead after this photo, so no pictures of the finished job!
<img src = "http://i167.photobucket.com/albums/u125/27Grainfield/424IH/FunWithFire_zps646c9f9e.jpg">