F12 sleeve diameter

F-12 guy

Member
Does anyone know the OD and ID of a farmall F12 sleeve? I"m needing to get a puck made for my sleeve puller. Thanks Josh in Nc
 
The inner diameter is 3 inches I believe, same as the farmall A/B/C sleeve. Just add a little to that and you should be good. Tractordata.com should have the measurements if you want to double check.
 
Sine they're wet sleeves you can drive them out using a piece of oak and a big hammer. I did this on a Farmall A in 1975 that was stuck. Hal
PS: I reused the rods on the new pistons that came with the sleeve kit. Hal
 
You just need a puck bigger than the bore. The sleeves stick down into the lower end quite a bit. Once you move them up to where your puck will touch the block they will come right out without the puller
 

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top