(800) 853-2651
SHOP NOW

Super A Hydraulic Fluid

A

asyrp43

Member
While repainting my Super A I'm decided to replace
the temp gauge for the touch control. I didn't
realize it would still be under presser so when I
pull the wire out the fluid went everywhere! Now
that it's all drained out I need to replace it.
I"m sure it needed to be replaced anyway. My
question what do I need to replace it with and how
much? I looked through my operators manual but
it didn't give any info other than how to operate
the touch control system.

Thanks!
Allen
 
It only takes a gallon or so.The amount will be listed in Capacitys/Specification section of the Owners manual.Use regular Hydralic oil.'Hi-tran'(or equivalent),or 10 wt nondetergent motor oil will also work.
 
I use Hy-Tran (I believe it's actually called Hy-Tran Ultra now) from caseIH. Most people tell you any good hydraulic fluid will work but I prefer Hy-Tran.

Al
 
Thanks....I just found an old metal jug of IH Hy-tran in the back of the barn. But I better buy a new can of it.

Thanks DeltaRed....I'll take a look at my manual again. I was looking in the wrong section.

-Allen
 
Can't remember for sure but my Super C has a screen filter in side of the reservoir where the touch control cable goes in I think the Super A will also have this might want to take out a clean before refilling.
 
The screen that kevin refers to is held in by 4 bolts in the plate from which you removed the temp gauge sending bulb. Be careful when pulling out the screen as they are fraigle. So far as I know only available from CIH and $$$$$. Buy a new gasket or be prepared to make a new one. Don't ask how I know this.
 
asyrp43, if you want to get rid of that can, and if it's in reasonably good shape, let me know. My email's open.

thanks!
Al
 
You must log in or register to reply here.

Similar threads

M
Super M transmission shaft seal
Replies
7
Views
186
Mark Poss
M
L
Super A Oil Pressure
2 3
Replies
48
Views
2K
kshansen
K
M
Searching for Super C Shafts
Replies
11
Views
543
Bull Gear
B
M
1952 Super A Hydraulic pump help
Replies
5
Views
273
BarnyardEngineering
BarnyardEngineering
M
Control Tower Differences - Super C
Replies
2
Views
243
mainer76
M
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top