I am rebuilding the steering on my H. The bearing that was in it was apart, missing felt, cup was half gone, etc.
I have posted a couple pictures and want to make sure I am putting back together as it should be and its a little difficult to see by the diagram.
Am I putting the bushing (#44a) back properly? I am putting the cupped side against the cupped side of the shaft, leaving the flat side against the bearing as seen in pic.
The new truss bearing (#44) seems to be at a slight angle. Which side goes against the bushing (44a)?
and last - does the felt and felt retainer go on top of the truss bearing?
Any help is greatly appreciated
I have posted a couple pictures and want to make sure I am putting back together as it should be and its a little difficult to see by the diagram.
Am I putting the bushing (#44a) back properly? I am putting the cupped side against the cupped side of the shaft, leaving the flat side against the bearing as seen in pic.
The new truss bearing (#44) seems to be at a slight angle. Which side goes against the bushing (44a)?
and last - does the felt and felt retainer go on top of the truss bearing?
Any help is greatly appreciated