|Farmall & IHC Tractors Discussion Forum|
Re: Farmall Cub
[Show Entire Topic]
[Show Entire Topic]
[Return to Forum]
[Log in to Reply]
I can't believe there's enough material in the block to bore a Cub engine out to 3"!
You'd be well into the water jacket, and there wouldn't be much more than a thin sliver of metal between the cylinders.
AFAIK, .060" over is about as far as you can go. That would make for a 2.685" bore, far from 3"
Are you sure you don't have an A or a Super A there? People commonly mistake one for the other, especially if they're new to tractors.
An A/Super A is about 1/3 bigger in every dimension. The Super A will have TWO hydraulic levers instead of one. The A/Super A will have the serial tag under the seat vs. on the steering bolster for a Cub.
If you truly have a Cub with a 3" bore, there are a lot of people on here that would like to see pictures. Whoever did it was either a total hack or a master engine builder.
|Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]|
| Copyright © 1997-2018 Yesterday's Tractor Co.|
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor Headquarters