Larry Hardesty
Member
This message is a reply to an archived post by Larry Hardesty on November 20, 2012 at 09:25:49.
The original subject was "Fast Hitch Post Hole Digger".
I finally got around to taking the post hole digger apart. There is no indicate of gasket size. They are very thin, but I suppose I can make them.
I need two or possibly three bearings. They say JAPAN EE11 on them.
I need two seals. THey have on them 17418 C/R
Any ideas where I can get them?
Thanks in advance.
The original subject was "Fast Hitch Post Hole Digger".
I finally got around to taking the post hole digger apart. There is no indicate of gasket size. They are very thin, but I suppose I can make them.
I need two or possibly three bearings. They say JAPAN EE11 on them.
I need two seals. THey have on them 17418 C/R
Any ideas where I can get them?
Thanks in advance.