(800) 853-2651
SHOP NOW

Farmall H wide front end

J

JAfromVA

New User
I just bought an original IH wide front to put
on my 41 H.I would like to make a mounting plate
so that it can be mounted in the short wheelbase
position.I am going to fabricate a 5/8" thick
plate and would like to know how far back the
IH plates set the axle.Does anyone know what
the hole spacings would be to duplicate the
original mounting plates?Thanks in advance.
JimAnderson
 
The setback plate will set the axle directly under the pedestal.The 'wheelbase'will be as it was before the WF.
 
You must log in or register to reply here.

Similar threads

F
Farmall 706 - Seeking Wide Front End - Mid Florida
Replies
5
Views
337
FinallyFarming
F
D
Farmall M Wide Front Swap
Replies
7
Views
622
Midway
M
C
Farmall H front tires
Replies
16
Views
710
caterpillar guy
C
M
Super C wide front bumper stops
Replies
7
Views
606
ihplowboy
I
B
Farmall H Spin on oil filter conversion?
Replies
4
Views
313
rustyfarmall
R
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top