|Farmall & IHC Tractors Discussion Forum|
Re: farmall cub govenor
[Show Entire Topic]
[Show Entire Topic]
[Return to Forum]
[Log in to Reply]
When you installed the governor, did you ensure the internal weights were free?
What about the finger plate that pushes against the weights, is it installed and in good shape?
Where did you get the spring that is installed between the governor rockshaft and the throttle rod?
Are the holes worn or elongated as described above?
What about the woodruff key in the rockshaft going into the governor, is it tight or loose?
What, if anything, was done to the carb internals?
What are the exact RPM's at idle and when it goes full throttle?
Before you start cutting and modifying parts, I'm sure there is an easy fix to cure the tractors problems.
|Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]|
| Copyright © 1997-2014 Yesterday's Tractor Co.|
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor Headquarters