RBoy

New User
JIM N I need help!
I am attempting to put a Behlen torgue generator unit on a 350 gas that already has a full hydraulic loader on it. The torgue unit has two keyed shafts coming out each end with different lengths. It also has two hydraulic plugs on it. It had a direct internal pump betwen the case and the dist.

How/which way does this unit mount? and where should I tap into hydraulic system?

I am a green guy, so this is foreign to me.
 
The hydraulic system is a modified open center system. it uses a pilot valve to turn on pressure to the system. two solutions on is to find that same tractor with PS and get the PS designed control block and attachments. The other way is to install an engine driven pump.
Honda has a nice remote reservoir pump.
If it is a Utility Tractor, The conversion is liable to twist too hard on the original gearbox ruining it. If it is a Farmall row crop, there should be no issur, the front shaft above the engine is cut, and couplers are welded on for the torque generator, and brackets to absorb the torque. If it was a Kit it should have the needed brackets. Jim
 
This is a Farmall row crop, and the torque generator is the only piece I have with the tractor. Any idea what an entire (new) kit would run?
 
Where are you at? Just got Char Lynn parts at Mike's Equipment in Buhler Kansas. Good guy and has acres of salvage. Started in combines (that is who we used way back when) but has Farmall parts.

Get a pump.
 

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top