well had to take carb off for float needle valve not sealing. super A all looks good now. pic. 7-8 show fluid in baster not going down been that way for 1 hr. also is my gov rod to carb bent? pic 10-11 thanks sorry so many pictures
Re: Carb work in reply to bob hawbecker, 11-22-2012 15:15:11
You need a new needle and seat, also the float could be hanging on the side of the housing. The rod appears to be slightly bent, should not be a problem. There is a screen inside the fitting you are pouring into. Never heard of one completely plugged. This post was edited by CNKS at 13:43:08 11/23/12.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.