Author	[Modern View]
PaulGinMn 08-29-2012 10:37:54 174.255.13.117 Report to Moderator	I just finished installing power steering on my H useing a char lynn torque generator and a gm pickup power steering pump. It took some work but it works great except my torque generator is leeking some out the front seal. I see they sell oring kits, is there any tricks or special tools needed to replace these orings? [Reply]   [No Email]
Paulginmn 08-29-2012 13:46:20 174.253.146.16 Report to Moderator	Re: H charlynn power steering install in reply to PaulGinMn, 08-29-2012 10:37:54   I am planning on makeing a shield yet, I just hooked up the hoses this morning and found the leak. I also need to wire the hitachi altenator yet. I pull a 2 bottem plow with this tractor in the fall and the power steering is going to make it a joy to plow with. [Reply]  [No Email]
GordoSD 08-29-2012 12:02:17 64.33.250.162 Report to Moderator	Re: H charlynn power steering install in reply to PaulGinMn, 08-29-2012 10:37:54   Be sure and make a mark with a file on the upper and lower half. You want to get it back there on rassembly. Any parts store with O rings should be able to fix you up with the one large one that fails and causes leaking. You also need to install a "swivel coupling" Has a small amount of side to side and fore and aft play to keep from overworking the TG. I found one painted green for a JD that was thr one included with the Charlyn kit. Maybe somone else can give you the proper name and source for it. [Reply]  [No Email]
Paulginmn 08-29-2012 13:42:21 174.253.146.16 Report to Moderator	Re: H charlynn power steering install in reply to GordoSD, 08-29-2012 12:02:17   I do have a swivel coupleing ahead of the torque motor I made sure that it wasnt bottemed out when I drilled the shaft also. Thanks for the info [Reply]  [No Email]
wayne in mn 08-29-2012 12:48:13 64.118.12.213 Report to Moderator	Re: H charlynn power steering install in reply to GordoSD, 08-29-2012 12:02:17   Should a heat shield be placed between the hoses & exhaust manifold? [Reply]  [No Email]
Janicholson 08-29-2012 13:24:00 199.17.6.249 Report to Moderator	Re: H charlynn power steering install in reply to wayne in mn, 08-29-2012 12:48:13   Wayne is catching a good point of probable failure. A metalic wrap, or sheetmetal reflector should be used between the hose and that 1200 degree manifold. Jim [Reply]  [No Email]