(800) 853-2651
SHOP NOW

international harvester 3200 a skid steer Engine replacement

M

marekply1962

New User
I have a international harvester 3200 a skid steer with Wisconsin engine vh4d that needs to be replaced due to all the gears being broken including the governor assembly. I was wondering if anyone has ever replaced this Wisconsin engine with a different type of engine or a newer one that would be equivalent to the Wisconsin vh4d and would fit the international harvester 3200 a skid steer without any modifications. Even if you know a place where i could purchase or a place where to rebuild or any information on how to replace the gears would be greatly appreciated. Thanks in advance.
Sincerely,
Marek
 
We needed to replace our skidsteer motor. I believe it was a VH4D also. Went to a salvage yard and got one out of a swather of some kind. The crankshaft was different and would not bolt up the the pump. Same engine, different crankshaft, so if you are thinking about an engine swap, might need to keep that in mind.
 
Just take your pulley to a machine shop and have them bore it out to fit the crankshaft on the Wisconsin VH4D off of the swather. I had my pulley machined to fit a straight crankshaft engine. You'll probably have to cut the shaft off, then drill and tap it for the bolt to hold pulley on crankshaft.

Keith
 
Now WHY would anyone spend $3000.00 for a motor on an old machine. That is way more than I paid for my Bobcat.
Especially when you can buy VH4D for less than couple hundred dollars. Or spend around $300.00
for new pistons, rings, main bearing and rod bearing.

Keith
 
You must log in or register to reply here.

Similar threads

7
New Holland LX 565 skid steer that doesn't seems to have governor response after overhaul
Replies
0
Views
83
7000Eric
7
B
Case 1816c loses power and dies when drive pumps are engaged.
Replies
7
Views
223
Fritz Maurer
F
P
International 2500B loader backhoe
Replies
4
Views
216
PineRiverPat
P
B
Help with JD90 skid steer drive motor.
Replies
1
Views
300
Muir hill 101
M
C
3pt hitch goes up and down but will not maintain a position when stopped it goes back up
2
Replies
34
Views
753
camfire
C
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top