Farmall_H_Puller
New User
Will one piece Farmall rear weights weights fit on a IH 966
- Thread starter Farmall_H_Puller
- Start date
Farmall H, Yes depending on how much wt you want to carry. Unless you have CaCl & H20 then I would say you need equal # of 2 piece wt for the insides, leaving the 1 piece for the outsides.
For every pair you add to rear corner that is about 300 lbs. You can use the 4 holes in the cast wheel, and the wts and go as wide as 5 & 5 ins and outs fairly easly.
I have a 966 also Mine has the huge one piece aftermarket cast wts 950 + - lbs. No fluid in tires either, cast only. I have a loader on mine so I am a huge believer in cast wt.
So the 2 piece/1piece method as I described above is how I would approach this. 1 single wt is not much help in the grand scheme of things. Hope this helps.
Later,
John A.
For every pair you add to rear corner that is about 300 lbs. You can use the 4 holes in the cast wheel, and the wts and go as wide as 5 & 5 ins and outs fairly easly.
I have a 966 also Mine has the huge one piece aftermarket cast wts 950 + - lbs. No fluid in tires either, cast only. I have a loader on mine so I am a huge believer in cast wt.
So the 2 piece/1piece method as I described above is how I would approach this. 1 single wt is not much help in the grand scheme of things. Hope this helps.
Later,
John A.
Farmall_H_Puller
New User
ok thanks I thought they would fit the 966 but wasn't 100% sure
rustyfarmall
Well-known Member
I've got two sets of rear weights on my H. The first set is the "split" 2 piece variety that came off of a 1066. The second set is the common one piece variety. All of the mounting bolt holes line up perfectly.
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy