Anonymous-0
Well-known Member
WHAT IS THE DIFFERENCE BETWEEN A FARMALL B AND A BN FARMALL..ALSO DID THE BN COME WITH A WIDE FRONT END..THANKS IN ADVANCE..
- Thread starter Anonymous-0
- Start date
muleboss
Member
- Location
- Burlington, Kansas
About 16 inches and NO
old
Well-known Member
- Location
- Camdenton Missouri
Well the B is very wide and the BN is a tad bit narrower in the rear. Both only came with a trike front but the front off an A will both on to them but would not really look right
Athol Carr
Member
The Farmall BN is 8 inches narrower than the Farmall B. treads 56 to 84 inches as against 64 to 92 inches. There was a Farmall BN sold at an auction just North of Christchurch, NZ 3 weeks ago that had a Farmall A front end on it. Looked quite an interesting combination. Sorry I did not have my camera. The Farmall A front end has available treads of 44 to 64 inches so will work in both Farmall BN and B cases but will have to have maximum tread to work with the B but 3 different treads available to match the BN. A Farmall C front axle might give a greater range of available treads.
Red Dave
Well-known Member
Athol Carr is correct. 8 inches of rear width.
It is accomplished by the differential shafts on the BN being 4 inches shorter on each side. 22 inches each side on the B, 18 inches on the BN. Either could have a single or dual wheel front end.
No BN came from the factory with a wide front end.
It is accomplished by the differential shafts on the BN being 4 inches shorter on each side. 22 inches each side on the B, 18 inches on the BN. Either could have a single or dual wheel front end.
No BN came from the factory with a wide front end.
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy