(800) 853-2651
SHOP NOW

Several H Questions

D

David A. Smith

Member
In the photo of the front wheel (back side) ... I see the race ... what's the other (exterior) ring? Do I need to replace it?
In the photo of the front wheel (front side) ... I see the face ... what's the other (exterior) ring? Do I need to replace it?
I've sent a photo of the grinder brushes I'm using to prepare for priming. I'm using mostly the fine brush. Does this look OK?
Finally ... how do you suggest I repair the hole shown above the guage window?
a19663.jpg

a19664.jpg

a19665.jpg

a19666.jpg
 
1 - remants of old seal, yes repalce it.
2 - Are you talking about the old black stuff? Is thats the old gasket, and yes replace it.
3 - Ive used both, the finer mesh for sheetmetal, the rougher for the cast parts.
4 - Couldnt tell you, but if you dont fix what caused the problem in the first place, itll happen again.
 
You'll be a lot better off just welding the holes in the hood. If you don't feel comfortable take it to someone who's good with a wire welder. It won't take but a minute to fill then you'll be able to grind down and smooth out a bit. The bracket that the gauges are mounted in has become loose and is setting at an angle and wore through...or the "pads" that your gas tank is sitting on have deteriorated or were never thick enough to begin with. Replace these with thicker mounting pads...this will bring up the rear of the hood to the correct height and will keep it from rubbing on the gage mount.
 
The piece on the inner side of the wheel is the surface for the dust seal to ride on. If it is rusted or damaged you should replace it.

On the outer face what you are looking at is just the gasket.
 
You must log in or register to reply here.

Similar threads

J
460 wont steer
Replies
17
Views
539
used red MN
U
O
T4 100 V Skid Plate
Replies
7
Views
205
wh
wh
M
4560 tire/rim replacement
Replies
8
Views
435
BarnyardEngineering
BarnyardEngineering
C
1953 Super H water in oil
2
Replies
25
Views
1K
used red MN
U
J
3000 Gas Ignition Switch
Replies
1
Views
249
jchewie
J
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top