(800) 853-2651
SHOP NOW

300 wiring diagram

C

Craig T

Member
Yesterday I thought I had our problem figured out until I read what was posted. Today I put a rebuilt 6v starter on and replaced the wires again.

When we started it today it acted fine. We ran it for about 10 minutes, starting and stopping periodically. We felt the solenoid, regulator, and terminals and nothing got hot.

We used a diagram out of a 400 owner's manual, and from what we could tell they're identical. I'll ask the same question, could the starter/solenoid have caused our wires and amp gauge to burn up?
 
A bad connection at the solenoid (on the big terminal that has the battery negative cable hooked to it coulod cause the starting current to flow in a direction that would allow the wire to melt. Two items The starter motor always looks like a direct short to ground. It draws hundreds of amps, and has near zero ohms. JimN
 
You must log in or register to reply here.

Similar threads

C
Need wiring diagram for later SN super M
Replies
2
Views
338
D Slater
D
K
222 wiring diagram
Replies
2
Views
797
karl h
K
Pipestem
Wiring Diagram
Replies
4
Views
513
Pipestem
Pipestem
D
300U...leftover wiring????
Replies
2
Views
227
BarnyardEngineering
BarnyardEngineering
T
Alternator confusion on a Case-IH 395
Replies
16
Views
683
Texasmark
T
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top