BrianLivingstone
Member
Can anyone tell me how to modify this drawing to use a voltmeter in place of the ammmeter
Thanks . Brian
Thanks . Brian
- Thread starter BrianLivingstone
- Start date
Janicholson
Well-known Member
Take all the wires off the ammeter, and bolt them together (tape well, or use a small binding post
to make it tidy in the box.
Install volt meter in the hole. Attach one lead to ground, and the other to ignition switch where
it goes to the coil. Jim
to make it tidy in the box.
Install volt meter in the hole. Attach one lead to ground, and the other to ignition switch where
it goes to the coil. Jim
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy