(800) 853-2651
SHOP NOW

IH F-4 Mag..........

B

banjoman09

Well-known Member
Wind is about 40 mph here or more....the ground that went north last week is going back south this week!
I have been in the shop assembling my W-30; on the F-4 mag there is a "cap" on the back; tear-drop shape...that retards the timing. The small hole on the side of it was partially broke when I purchased it- broke another piece today installing the rod. Hope some one will tell me that I can change that cap out? And find one? Thanks.
 
Points cover/breaker housing cover. Sort of a fragile pot metal casting. Easily replaceable. If you've removed it to clean the points, all that's left is to pull a cotter pin and swap it. Rotate the flat retainer out of the way to pull it; a couple little tabs index it to the points housing.

Looks like Rice Equipment has them. I need to replace mine on the F12, lots of wear at that hole.

Chris B.
 
When I picked up my F12 and then F20, it was quite a learning curve with those mags. Both were hard starting. One had a bad coil and the other had corrosion in the coil lead out. They start easy now.

Chris B.
 
Am hoping this one I bought off a member is good- he said it is. It looks ok...now how do I change that cap? Easy right ? Thanks.
 
You must log in or register to reply here.

Similar threads

M
IH 350 U air filter and steering parts
Replies
4
Views
179
Janicholson
Janicholson
Hemmjo
860 Freeze Plug installation
Replies
12
Views
687
MarkB_MI
MarkB_MI
W
Farmall F-12 No Spark
Replies
10
Views
666
wowsk
W
H
1030 repurchase story
Replies
6
Views
2K
Ande
Ande
W
Help With Magneto on F-12
Replies
4
Views
887
John M
John M
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top