mtf
Member
- Location
- Bottom of the Bluegrass State
I am working on a super a and I need to know what the difference in heights should be on the machined surfaces of the flywheel?
I measure 1.2".
The clutch is only slightly worn, but even with adjustment clutch was not releasing properly. Pilot bushing was well worn.
I use pto on this tractor a lot for grain augers.
Thanks for any help. Nathan
I measure 1.2".
The clutch is only slightly worn, but even with adjustment clutch was not releasing properly. Pilot bushing was well worn.
I use pto on this tractor a lot for grain augers.
Thanks for any help. Nathan